OE Ref.:
25774006
Commercial Name:
Schrader Clamp-in Gen J 315MHz GM Black 51psi
OEM Sensor P/N:
25774006
Ean Code:
EZ-sensor® coverage:
YES
Nut Torque:
62 in-lbs (7 Nm) Nm
Screw Torque:
-- Nm
Valve Core Torque:
3.5 in-lbs (0.4 Nm) Nm
Note:
WARNING: This product contains chemicals including lead, which is known to the State of California to cause cancer and reproductive issues.
For more information, go to
www.P65Warnings.ca.gov.
EZ-sensor® GO is pre-programmed for all vehicles mentioned in the list. No programming is required before installation for the below applications. Additionally, the sensor can be programmed to 99% of all vehicle makes, models and years.
Click on item for more details:
This list is being continuously updated.
Part No.:
1081
20004
20004
Commercial Name:
TPMS Service Pack
Note:
20004 replaces 20002 going forward from March 1, 2018
Contents: 1 Aluminum Nut, 1 Plastic Sealing Cap, 1 Rubber Grommet, 1 Nickel Plated Valve Core
EZ-sensor® GO can be programmed to any Make Model and Year shown in this list.
Click on item for more details:
This list is being continuously updated.
Relearn Summary: Stationary Relearn
Relearn Description1. Apply parking brake. Turn ignition to ON/RUN position (engine off).
2. Turn headlight switch from OFF to parking lamps 4 times within 4 seconds. A double horn chirp will sound and the TPMS telltale will begin blinking to indicate the learn mode is enabled.
3. Starting at the LF tire, use TPMS activation tool to activate sensor, once the vehicle receives the signal from the sensor, the horn will chirp.
4. After horn sounds, proceed as in step 3 for the next 3 sensors in the following order: RF, RR, LR.
5. After LR sensor has been learned, turn ignition to OFF position. Adjust all tires to pressure listed on tire placard.
-Troubleshooting Tip: In order for vehicle to be placed into learn mode, the parking brake MUST be functional. Verify brake is engaged by seeing BRAKE illuminated on dash display. On some 2007 ½ GM trucks the headlight switch will not enable the TPMS learn mode.
See steps below:
1. Apply parking brake. Turn ignition to ON position (engine off).
2. Using the DIC control, Press Vehicle Information Button until “Press √ to Relearn” displays. Press √, a double horn chirp will sound and the TPMS telltale will begin blinking to indicate the learn mode is enabled.
3. Starting at the LF tire, use TPMS activation tool to activate sensor, once the vehicle receives the signal from the sensor, the horn will chirp.
4. After horn sounds, proceed as in step 3 for the next 3 sensors in the following order: RF, RR, LR.
5. After LR sensor has been learned, turn ignition to OFF position. Adjust all tires to pressure listed on tire placard. *See "FIGURE 1" below:
Relearn Procedure as PDF document
Mounting Instructions
Note:
Sensor images shown in this document are for illustration purpose only!
Phisical sensor body may be different.
Non contractual document!
For tecnical information, please contact your supplier or leave a message at info@Schrader TPMS E-Catalog.com
User Manual/Quick Start Guide
Note:
Document contains full description user manual and / or Quick Start Guide. Non contractual document!
For technical information, please contact your supplier or leave a message at SchraderNA@sensata.com
Approvals and Declarations
Note:
Package contains FCC, IC and CE certifications
Physical sensor body may be different.
Other documents can be also found
here.